Two Dimensional Wind Tunnel

Product Description

Description of Two Dimensional Wind Tunnel: Two Dimensional Wind Tunnel is designed for use with either Air Flow Bench or Fan Test Stand. The wind tunnel has a high aspect ratio clear acrylic test section 250 mm high and 65 mm deep. The test section can be fitted with two interchangeable variable incidence model carriers, one with a cylindrical section and the other with a low velocity sub-sonic aerofoil. The cylinder has a single static tapping which can be used to plot the pressure profile around the cylinder. The aerofoil has 14 static pressure tappings allowing the pressure profile around the nose and along both the upper and lower cambered surfaces to be measured. Pressures can be measured using Multitube Manometer or the Multiple Pressure transducer Module which provides 0-10 Volt analogue outputs for connection to a computer or data logging system. Experimental Capability of Two Dimensional Wind Tunnel: Pressure profile around a transverse cylinder and derivation of drag force coefficient Pressure profile around an aerofoil section and derivation of lift and drag forces and coefficients Direct measurement of drag on a transverse cylinderDirect measurement of lift and drag on an aerofoilVariation of lift and drag forces and coefficients, and liftdrag ratio with aerofoil incidence Specification of Two Dimensional Wind Tunnel: A two dimensional wind tunnel with nominal dimensions of the working section of 250 mm high by 65 mm deep. The material of construction is clear acrylic, where appropriate, and the front section is removable. Two models are provided, including an aerofoil section having pressure tappings around the periphery enabling a pressure profile around the model to be drawn for different angles of attack. Provision is made in the test section for the insertion of an optional smoke generator rake; traversing pitot-static tube and the optional anemometer. The test section can be traversed at a number of planes allowing the uniformity of the flow to be verified. The pitot-static tube or anemometer can also be used upstream of the test models to determine the undisturbed incident flow velocity. The model carrier can be directly coupled to the optional two component balance which provides independent measurement of lift and drag forces. A further option, is available to replace the spring balance with load cells providing 0-10 Volt analogue outputs for connection to a computer or data logging system. A Boundary Layer Experiment is also available. Required Ancillaries of Two Dimensional Wind Tunnel: Multitube Manometer.Two Component Balance.Boundary Layer Experiment.Smoke GeneratorAnemometerData Logging for Multiple PressuresData Logging for Two Component Balance