Manual Absorption And Stripping Plant

• Column with a height of 1000 mm packed with Raschig rings
• Heat exchanger with an exchange surface of 0.5 m² installed at the bottom of the column
• Feed tank with a capacity of 30 litres
• Metering pump with a flow rate of 270 litres per hour including a pneumatic actuator that can be controlled by a signal of 0.2 to 1 bar
• 2x pneumatic control valves Cv = 0.2 and 0.08
• Electronic thermal mass flowmeter with a range of 0 to 600 litres per hour and electronic display for measuring the flow rate of the gas to be absorbed
• Electronic thermal mass flowmeter with  a range of 0 to 6000  litres per hour and electronic display for measuring the flow rate of the carrier gas .
• Electronic differential pressure transmitter with a range of 0 to 200 mm H₂O and 4-20 mA output signal
• 3x digital thermocouples with pt100 probes protected by stainless steel shield sleeves
• 3x electronic temperature indicators
• 3x pneumatic manual control valves
• Pipework manufactured from stainless steel
• Electrical control panel in main cabinet
• Emergency stop button.

• 400 Vac 50 Hz three-phase 1000 VA (Other voltages and frequencies available on request)

Automated Absorption And Stripping Pilot Plant      DICE048