Bending Device

Product Description

Bending Device

Technical Description of Bending Device

Using this accessory for the universal material teste a bending bar is investigated. This is mounted on two supports and loaded with a point force generated by the tester. By sliding the bearing it is possible to apply the force in different positions and change the support width. An I-section steel beam is used as the base. This is straightforwardly bolted to the lower cross-member on the. Using the apparatus, the relationship between load and elastic deformation can be demonstrated. The influence of the modulus of elasticity and planar moment of inertia is also demonstrated.

Specification of Bending Device

• Supplementary experiment on the universal material tester for the elastic deformation of bending bars subject to a point force
• Test bar made of cold drawn flat steel
• Cross-section 40x12mm, length 320mm
• Support width adjustable width
• Moveable bearing, semicircular seat
• I-section steel beam as bearing base
• Comprehensive experiment instructions, also as pdf

Technical Data of Bending Device

• Bending bar
• Flat steel cold drawn
• Cross-section: 40x12mm
• Length: 320mm
• Support width, adjustable: 100...300mm